XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

			AMENDMENT HISTORY - SIN2088

XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX


VERSION		DCR		DATE
 V2.33         29822	       30.8.07 

1. Applied some stop/start (ABS) action to card driver to possibly overcome some card 
   slippage problems.


XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX


VERSION		DCR		DATE
 V2.31         29761		29.6.07 

Reason for change:

Due to problem in the laminator firmware. After sending the S "Save to FLASH" command, 
the laminator responds with a "+/r" message.There should be no serial data generated 
by the laminator in response to this command.


 Details of change:

the V2.31 from 16.01.2007 is a copy from V2.30.
The only change the setting of the following C-Line on commentary

//    printf("+\r"); // in V2.31 keine Quittierung fuer S-Kommando

XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX